employee from 01.01.1980 to 01.01.2022
Ulyanovsk, Ulyanovsk, Russian Federation
Russian Federation
Computer simulation of technological parameters in the milling process of polycarbonate workpieces under various processing modes is realized. The parameters are recorded at various points in the contact time of the milling cutter tooth with the workpiece. The regularities of changes in the parameters of the milling process, including forces and temperatures in the contact zones of the facing with the cutter tooth or in case of tooth contact with the workpiece, depending on the elements of the milling mode, are found. It’s also found that the temperatures in the contact zone of the tooth with the workpiece are higher than in the contact zone of the tooth with the facing. The pattern of temperature distribution in the surface layer of the workpiece is distilled. Mathematical dependences describing the relationship of temperatures with the elements of the milling mode, are obtained
processing mode, modeling, milling, polycarbonate, temperature field, temperature, force
1. Unyanin, A.N. Analytical study of the temperature field during milling with the imposition of ultrasonic vibrations / A.N. Unyanin // Vestnik RGATU im. P.A. Solovyov. - 2017. - No. 2 (41). - S. 220 - 235.
2. Reznikov, A.N. Thermal processes in technological systems / A.N. Reznikov, L.A. Reznikov. - M.: Mashinostroenie, 1990. - 288 p.
3. Vorontsov, A.L. Development of a new theory of cutting. Mathematical description of the formation of chips of various types, pulsations of cutting forces and parameters of contact between the machined surface of the workpiece and the rear surface of the cutter / A.L. Vorontsov, N.M. Sultan-Zade, A.Yu. Albagachiev // Bulletin of Mechanical Engineering. - 2008. - No. 7. - P. 56 - 61.
4. Vorontsov, A.L. Development of a new theory of cutting. Practical calculations of cutting parameters during turning / A.L. Vorontsov, N.M. Sultan-Zade, A. Yu. Albagachiev // Vestnik mashinostroeniya. - 2008. - No. 9. - P. 67 - 70.
5. Toolmaker's Handbook / I.A. Ordinartsev, G.V. Filippov, A. N. Shevchenko and others / Ed. ed. I.A. Ordinartseva. - L .: Mashinostroenie, Leningrad branch, 1987. - 846 p.
6. Vasin, S.A. Cutting materials: Thermomechanical approach to the system of interconnections during cutting: a textbook for technical universities / S.A. Vasin, A.S. Vereshchak, V.S. Kushner. - M .: Publishing house of MSTU im. N.E. Bauman, 2001. - 448 p.
7. Unyanin, A.N. Modeling of the temperature field during milling blanks of thin-walled parts / A.N. Unyanin, I.V. Semdyankin. - Innovations in mechanical engineering: collection of works of the 12th int. scientific and practical. conf. - Novosibirsk: Iz-vo NSTU, 2021. - S. 59 - 66.
