Lipeck, Lipetsk, Russian Federation
Elec, Lipetsk, Russian Federation
On the basis of the analysis of cutting forces operating in the contact area of a ball mill with the surface under machining there are offered dependences for the technological parameters definition. The use of the dependences obtained allows increasing productivity of volumetric milling areas left unprocessed after semifinish milling without use of additional adaptive devices
volumetric milling, unprocessed areas, productivity
1. Batuev, V.A., Batuev, V.V. Feed control with purpose of ensuring accuracy at special-complex surfaces on NC ma-chines / Proceedings of the Inter. Scientif.-Tech. Conf. - Bar-naul: Publishing House of Polzunov STU of Altay, 2003. - pp. 11-12.
2. Batuev, V.V. Productivity ensuring at finish milling of special-complex surfaces under conditions of the specified accuracy / Efficient Technologies in Mechanical Engineering: Proceedings. - Chelyabinsk: Publishing House of SUSU, 2005. - pp. 91-94.
3. Guzeev, V.I. Dynamic adjustment errors at formed component turning on NC machines / Finishing Efficient Technology. Chelyabinsk: ChPI, - 1980. - No.249. - pp. 16-18.
4. Guzeev, V.I., Vatuev, V.V. Account of previous ma-chining marks impact upon accuracy of special-complex sur-faces milling / Efficient Technologies in Mechanical Engineer-ing: Proceedings - Chelyabinsk: Publishing House of SUSU, 2003. - pp. 115-117.
5. Kozlov, A.M., Malyutin, G.E. Productivity increase at spatial milling of unprocessed areas // Proceedings of the V-th Inter. Scientif.-Tech. Conf. “Mechanical - Basis of Russia Technological Development”. Kursk, May 22 - 24, 2013 - 2013. - pp. 307-310.
6. Kozlov, A.M., Malyutin, G.E. Productivity increase at finish spatial milling on NC machines // Science Intensive Technologies in Mechanical Engineering. - 2013. - No.11(29). - pp. 14-18.
7. Kozlov, A.M., Malyutin, G.E. Computation of chip shrinkage factor at finishing with ball mills // Proceedings of the III-d Inter. Scientif.-Pract. Conf. “XXI-st: Fundamental Science and Techniques”. Moscow. January 23-24, 2014. - pp. 89-94.
8. Malyutin, G.E. Cutting force definition at finish spatial milling of concave complex surfaces with ball mills on NC machines // Fundamental and Applied Problems of Engineer-ing and Technology. - 2014. - No.4 (306). - pp. 74-81.
9. Kozlov, A.M., Malyutin, G.E. Efficiency increase of 3D finish spatial milling on NC machines // Science Intensive Technologies in Mechanical Engineering. - 2014. - No.6(36). - pp. 39-44.
10. Kozlov, A.M., Malyutin, G.E. Productivity increase at concave complex surface milling on NC machines. // Bulletin of Mechanical Engineering. - 2014. - No.12. - pp. 71-75.
