MODELING OF POLYMER FLOW IN SECTIONS OF SMALL CHANNELS
Rubrics: MECHANICAL ENGINEERING
Authors:
1.
Bryansk State Technical University
(Department of Materials Science and Mechanical Engineering, Head of the Department, Associate Professor)
employee
Bryansk, Bryansk, Russian Federation
employee
Bryansk, Bryansk, Russian Federation
2.
Bryansk State Technical University
(department “Metal Cutting Machines and Tools”, Professor)
employee
Bryansk, Bryansk, Russian Federation
employee
Bryansk, Bryansk, Russian Federation
3.
Bryansk State Technical University
(Department of Metal Cutting Machines and Tools, Associate Professor, Head of the Department)
employee
Bryansk, Bryansk, Russian Federation
employee
Bryansk, Bryansk, Russian Federation
4.
Bryansk State Technical University
(Department of Metal Cutting Machines and Tools, Associate Professor)
employee
Bryansk, Bryansk, Russian Federation
employee
Bryansk, Bryansk, Russian Federation
Type:
Article
Pages:
from 34
to 41
Status:
Published
Received:
15.10.2023
Accepted:
24.10.2023
Published:
30.11.2023
Subject area:
VAC 2.5.6 Технология машиностроения
UDK 678 Промышленность высокомолекулярных веществ. Резиновая промышленность. Промышленность пластмасс
BBK 345 Общая технология машиностроения. Обработка металлов
UDK 678 Промышленность высокомолекулярных веществ. Резиновая промышленность. Промышленность пластмасс
BBK 345 Общая технология машиностроения. Обработка металлов
Language:
Russian
Keywords:
thermosetting plastic, modeling, hot pressing
Abstract (English):
The problems of modeling the flow of polymers in channels with a small section in the overall production of about 2-3 cm3 are considered. The influence of channel dimensions on the thermosetting plastic movement in such channels is described. The arguments are given to prove necessity of careful control of the flow sections of small channels in the production of polymer products. A simulation of pressing a small product with the thermosetting plastic in a mold with a built-in filling element is carried out. The location of the filling element will allow to assess the nature of the flow front movement in the mold cavity most closely to reality. An attempt is made to analyze the influence of pressing conditions on obtaining a high-quality product and the behavior of the filling element in the mold cavity.
The problems of modeling the flow of polymers in channels with a small section in the overall production of about 2-3 cm3 are considered. The influence of channel dimensions on the thermosetting plastic movement in such channels is described. The arguments are given to prove necessity of careful control of the flow sections of small channels in the production of polymer products. A simulation of pressing a small product with the thermosetting plastic in a mold with a built-in filling element is carried out. The location of the filling element will allow to assess the nature of the flow front movement in the mold cavity most closely to reality. An attempt is made to analyze the influence of pressing conditions on obtaining a high-quality product and the behavior of the filling element in the mold cavity.
Keywords:
thermosetting plastic, modeling, hot pressing
thermosetting plastic, modeling, hot pressing
1. Filatov VI, Korsakov VD. Technological preparation of molding processes of plastics. Leningrad: Polytekhnika; 1991.
