TESTER-N-CALCULATE ARRANGEMENT TO MAKE CUTING FORCE OF WOOD
Journal: ACTUAL DIRECTIONS OF SCIENTIFIC RESEARCHES OF THE XXI CENTURY: THEORY AND PRACTICE
Volume 4 № 1
, 2016
Rubrics: TECHNICAL SCIENCE
Authors:
Type:
Article
Pages:
from 154
to 157
Status:
Published
Received:
26.04.2016
Accepted:
26.04.2016
Published:
26.04.2016
Language:
Russian
Keywords:
tester-n-calculate complex, digital converter pickoff signals cutting force wood.
Abstract (English):
On the basis of the universal dynamometer bridge UDM-600 is built for : tester-n-calculate complex with digital signal converter strain. Spend calibration UDM-600 on three axes and torque. The dependences of the conversion of conditional units in the actual values of the three components of the cutting forces along the axes X, Y, Z and torque 0XY plane. The efficiency and effectiveness of the complex was confirmed by trial experiments.
On the basis of the universal dynamometer bridge UDM-600 is built for : tester-n-calculate complex with digital signal converter strain. Spend calibration UDM-600 on three axes and torque. The dependences of the conversion of conditional units in the actual values of the three components of the cutting forces along the axes X, Y, Z and torque 0XY plane. The efficiency and effectiveness of the complex was confirmed by trial experiments.
Keywords:
tester-n-calculate complex, digital converter pickoff signals cutting force wood.
tester-n-calculate complex, digital converter pickoff signals cutting force wood.
