Saratov, Saratov, Russian Federation
Volgograd, Volgograd, Russian Federation
The improvement of mathematical and methodical support to realize an enlarged unit of design procedures of the analysis of requirements to the assembly of precision products being a part of a complex approach is considered. It is shown that this ensures the efficient fulfillment of assembly operations on the basis of the tie between a technological preparation of processing and assembly production of precision products.
precision product, requirement to assembly, complex of design procedures, technological preproduction;,design dimensional analysis;,structural element
1. Suslov, A.G., Dalsky, A.M. Scientific Fundamentals of Engineering Technique. - M.: Mechanical Engineering, 2002. - pp. 684.
2. Nazariev, A.V., Bochkaryov, P.Yu., Bokova, L.G. Complex approach to fulfillment of technological preparation of multirange machining-processing production based on taking into account peculiarities of precision product assemblage // Reference Book. Engineering Journal with Appendix. - 2019. - No.3(264). - pp. 35-42.
3. Bochkaryov, P.Yu. System presentation of planning for engineering processes of machining // Engineering Technique. - 2002. - No.1. - pp. 10-14.
4. Lelyukhin, V.E., Kolesnikova, O.V. Analysis and Calculation of Dimensional Chains Based on Dimensional Tie Graphs // Bulletin of ISh DVFU. - 2015. - No.4(25). - pp. 29-34.
5. Grechnikov, F.V., Tlustenko, S.F. Design of assemblage technological process on criteria of precision // Bulletin of Academician Korolyov State Aerospace University of Samara. - 2011. - No.3-4. - pp. 38-43.
6. GOST 2.101-2016. Single System of Design Documentation. Product Kinds. - M.: StandardInform, 2018. - pp. 12.
7. Anuriev, V.I., Zhestkova, I.N. Designer-Mechanician’s Reference Book: in 3 Vol. - M.: Mechanical Engineering, 2001.
8. Bazrov, B.M. Fundamentals of Engineering Technique: textbook - M.: Mechanical Engineering, 2005. - pp. 736.
9. GOST 2.305-2008. Single System of Design Documentation. Images - Kinds, Sections, Profiles. - M.: Standardinform, 2009. - pp. 27.
