IMPACT OF ELECTROLYTE AND VOLTAGE CONCENTRATION IN CIRCUIT UPON RELIABILITY OF TAPPING IN OPENINGS WITH SUPER-SMALL DIAMETER USING ANODE MACHINING
Authors:
1.
Institute of Design and Engineering Informatics of the Russian Academy of Sciences
(Leading Researcher)
employee
Russian University of Transport (MIIT) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
employee
Russian University of Transport (MIIT) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
2.
Institute of Design Technological Informatics of RAS
(Post graduate student)
graduate student
Moskva, Moscow, Russian Federation
graduate student
Moskva, Moscow, Russian Federation
3.
PC “Korolyov Plant
(zamestitel' general'nogo direktora)
Ivanovo, Ivanovo, Russian Federation
Ivanovo, Ivanovo, Russian Federation
Type:
Article
Pages:
from 14
to 18
Status:
Published
Received:
29.10.2018
Accepted:
30.11.2018
Published:
30.11.2018
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
Language:
Russian, English
Keywords:
thread cutting, super small diameter, process reliability, moment formation, electrochemical treatment
Abstract (English):
In the paper there is considered an impact of electrolyte and voltage concentration in a circuit upon reliability of tapping in openings with super-small diameter using anode machining (AM). The impact of changes of sodium chloride mass fraction in an electrolyte solution and the impact of voltage supplied in the course of machining threaded openings with a super small diameter (≤ M1.4) using AM is shown.
In the paper there is considered an impact of electrolyte and voltage concentration in a circuit upon reliability of tapping in openings with super-small diameter using anode machining (AM). The impact of changes of sodium chloride mass fraction in an electrolyte solution and the impact of voltage supplied in the course of machining threaded openings with a super small diameter (≤ M1.4) using AM is shown.
Keywords:
thread cutting, super small diameter, process reliability, moment formation, electrochemical treatment
thread cutting, super small diameter, process reliability, moment formation, electrochemical treatment
1. Tomachyov, S.A. Theoretical fundamentals of tapping // MSIU. Inter-college Proceedings. - 1999. - pp. 13-18.
2. Kulikov, M.Yu., Yagodkin, M.V. Reliability investiga-tions of tapping in openings with super small diameter // Transactions of KBSU. - 2015. - 2015. - No.5. - pp. 153-156.
3. Kulikov, M.Yu. Yagodkin, M.V. Tapping peculiarities in openings of super small diameters // Bulletin of BSTU. 2016. No.3. - pp. 153-156.
4. Matveev, A.A. Precise Thread Cutting. - M.: Mechani-cal Engineering, 1978. - pp. 88.
5. The Anodic Mechanical Machining Application of Thread Cutting of Small Diameters. Kulikov M.Yu., Yagodkin M.V., Larionov M.A. Sheptunov S.A. Proceed-ings_IT&QM&IS-2017 20(1). - C. 724-727.
